1. Remove the steering wheel (1) with steering puller and the rubber steering cover (10). 2. Remove the throttle grip (2). 3. Remove the rear bonnet (3). 4. Disconnect the 4P connector (5), the 8P connector (6), the 6P connector (7) and the 20P connector (8). 5. Disconnect the hour-meter cable and remove the meter… Read More »
1. To open the bonnet (1), hold the bonnet with a hand and pull the release lever and open the bonnet. 2. Disconnect the battery negative cable. 3. Disconnect the head light connector (3). 4. Remove the snap pin (4) and disconnect the bonnet damper (5) from the bonnet. 5. Remove the screws (6). 6.… Read More »
1. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. (When reassembling) • Fill up new oil to the upper line of the gauge (2) from the oil inlet port after removing the oil inlet plug… Read More »
1. Check the engine and clutch housing case are securely mounted on the disassembling stands. 2. Remove the engine mounting screws, and separate the clutch housing case from the engine. (When reassembling) • Apply grease to the splines. • Apply liquid gasket (Three Bond 1206C or equivalent) to joint face of the engine and clutch… Read More »
1. Remove the screw (4) then tap out the spring pin (3). 2. Slide the propeller shaft cover 1 (5) to the front and the cover 2 (6) to the rear. 3. Tap out the spring pins (1) and then slide the coupling (2) to the front and coupling (8) to the rear. (When reassembling)… Read More »
Suction Hose and Delivery Pipe 1. Disconnect the suction hose (1). 2. Remove the delivery pipe (2). (When reassembling) • When reassembling the delivery pipe, install the new copper washers securely.
1. Remove the grip (6). 2. Remove the floor sheet cover (1) and the center cover (2). 3. Disconnect the differential lock spring and rod. 4. Disconnect the brake pedal springs and remove the step (3) (R.H.). 5. Remove the throttle rod (4) and the meter panel support (5). (When reassembling) • Be sure to… Read More »
1. Remove the screw from support (1) and the steering joint shaft (2). 2. Remove the accelerator rod (3). (When reassembling) • Lift the universal joint so that there should be a clearance (A) of more than 5 mm (0.2 in.) between the universal joint and flywheel housing. Then fit the support (1) in position.… Read More »
1. Disconnect the wiring (1). 2. Disconnect the 4P connector (3), the starter relay (2), the engine stop solenoid relay (5) and the flasher unit (4). 3. Remove the wiring from the rear bonnet support.
1. Disconnect the wirings (1). 2. Remove the clip (8) and disconnect the wirings (2). 3. Disconnect the 1P connector (3), (7) and the wiring (6), (5). 4. Remove the shutter plate (4) and the wirings from engine.