1. Remove the bushings right (4) and left side (3). (When reassembling) • When press-fitting new bushings (3), (4) with a press-fitting tool (see page G-51) observe the dimensions described in the figure. • Apply transmission fluid to the hydraulic cylinder boss and bushing. • Press- fit the bushing so that each seam face… Read More »
1. Disconnect the position control rod from feedback lever. 2. Remove the lift arm setting screws. 3. Draw out the hydraulic arm shaft (5) and right lift arm (6) as a unit. 4. Take out the hydraulic arm (1). 5. Remove the collar (3) and O-ring (2). (When reassembling) • Align the alignment marks of… Read More »
1. Tap out the spring pin. 2. Remove the hydraulic rod. 3. Push out the hydraulic piston (1). (When reassembling) • Install the piston, noting O-ring and back-up ring (3). (See figure.) • Apply grease to the piston bottom contacts with hydraulic rod. • Apply transmission fluid to the cylinder, and then install the hydraulic… Read More »
1. Remove the lowering speed adjusting valve from hydraulic cylinder block. 2. Tap out the spring pin (8), and remove the grip (5). 3. Remove the internal cir-clip (4), and remove the hydraulic adjusting shaft (2). 4. Remove the internal cir-clip (6) and draw out the adjusting collar (7). (When reassembling) • Install the hydraulic… Read More »
1. Loosen and remove the hydraulic cylinder assembly mounting screws and nuts. 2. Support the hydraulic cylinder assembly with nylon lift strap and hoist, and then take out it.
1. Remove the support (1) and the position lever (5). 2. Remove the joint screw (2). 3. Remove the clips (3). 4. Disconnect the wirings (4). (When reassembling) • When tightening the joint screw (2), install the new copper washers firmly.
1. Remove the seat (1). 2. Remove the grip (2). 3. Remove the grip (4) [4WD]. 4. Remove the position control lever guide (3). 5. Remove the floor seat cover (5).
1. Remove the top link (1). 2. Remove the rubber spring (2) and lift-rods (3). 3. Disconnect the negative cable.
1. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. (When reassembling) • Fill up new oil to the upper line of the gauge (2) from the oil inlet port after removing the oil inlet plug… Read More »
After reassembly, perform break-in operation in the following manner, and check the pump for abnormality before use. If the pump temperature should rise noticeably during running-in, recheck soul be performed. 1. Install the hydraulic pump to the tractor, and mount the suction pipe and delivery pipe securely. 2. Set the engine speed at 1300 to… Read More »