Reference ( 1 ) PTO Indicator Light Check Action: Observe PTO indicator light on instrument panel when key switch is turned to On position. Light should come on and go off after light check cycle. Light should remain off if the PTO switch is in the off position. It should come on if the PTO… Read More »
Reference ( 1 ) Perform Rear Differential Lock Operational Check Action: Set engine speed to low idle. Drive tractor straight forward at slow or moderate speed. Engage differential lock pedal and turn steering sharply in either direction. Tractor should have tendency to go straight forward, or cause inside rear tire to slip. Release differential lock… Read More »
Reference ( 1 ) Preliminary Checks Action: Make the following checks before installing test equipment: [1] – Ask Operator: How is machine performing? When does it malfunction? In what applications? [2] – Check maintenance records for: Proper service intervals Unusual, frequent or similar failures [3] – If performing MFWD Preliminary Checks, check for: Damaged or… Read More »
[1] – Lift foot rest outer edge (A) and insert fender flange under foot rest. [2] – Insert fuel tank support bracket (B) into controls quadrant. [3] – Align attachment holes in foot rest and fender flange. [4] – IMPORTANT: Front bolt should be installed with assembly off of tractor if possible to ease alignment… Read More »
Remove the left side fender and fuel tank for access to the left side of the transmission or for repairs to the fuel tank. [1] – Place engine fuel shutoff valve (A) in closed position. [2] – →NOTE: Fuel tank capacity is 22.2 L (5.6 gal.). Loosen hose clamp (B) at tank filter. Remove hose… Read More »
[1] – Install fender over SCV, SCV lock, and rockshaft controls. [2] – Arrange fender wire harness (A) along top of fender. [3] – Lift edge of foot rest to fit fender flange under foot rest. [4] – Loosely install foot rest bolts (B) and washers. [5] – Install console cover to fender over SCV… Read More »
Remove the right side controls console and fender for access to the SCV and right side of the transmission. [1] – Park machine safely. [2] – Remove rear wheel weight(s) (if installed). [3] – Remove right wheel. (See procedure in section 80-10.) [4] – Remove two hex shoulder bolts (A) and flat washers securing fender… Read More »
[1] – Remove two Phillips head screws (A). [2] – Remove two hex shoulder bolts (B). [3] – Remove height of cut adjustment knob (C). [4] – Remove closeout panel. [5] – Install closeout panel. a. Install closeout panel over rate of drop knob shaft and height of cut control shafts. b. Loosely install two… Read More »
[1] – Install display module with eight screws (A). [2] – Connect wiring harness connectors to turn signal switch (B), and light switch (C) on left side of panel. [3] – Connect wiring harness connectors to PTO switch (D) and key switch (E) on right side of panel. [4] – →NOTE: SN 210000— has two… Read More »
[1] – Remove cap from steering wheel. [2] – Remove nut securing steering wheel. [3] – Remove steering wheel using an appropriate puller if necessary. [4] – Remove two cap screws (A) securing instrument panel to firewall. [5] – Remove four screws (B), one from each side of cowl panel and two in center. [6]… Read More »